HYPERCELL® Hangers
Cables hangers
The hangers offered by ACOME are designed for
the installation of HYPERCELL® cables from
size of 1/4" up to 1-5/8"
in severe mechanical and environmental condi-tions.
These hangers must generally support the cable every meter to the
tower, in order to avoid any risk of slipperage or
longitudinal deformation due to its own weight, to the wind velocity, gusts and
induced turbulences and finally to vibrations of the tower.
In addition, in some area radial ice accumulation will
increase the overall loading.
In such case, a reduction in the hanger spacing is necessary.
Two types of hangers are proposed:
Single cable clip hangers
These stainless steel hangers can be rapidly fixed by clipping
on to the flat towers members of 2 to 6 mm thickness.
For round tower members, the hangers are simply attached
with a stainless steel adaptor clamp.
|
|
Once the hangers in place, the cable is simply snapped in
the springy support.
The advised 1.00 meter hanger spacings have been cal-culated
for wind velocity of 160 Km/h and 10 mm of
radial ice. Should one of these variable being changed,
then the spacing between hangers must be brought
back to 0.60m.
Multiple cables hook hangers
HYPERCELL® multiple cable runs hangers can attach two
or three cables directly on flat members of 40x40 or on
3.0 to 25mm flat and 8.0 to 25 mm round members.
These hangers are commonly used on crowded towers.
Once in place, cables are tighten in the calibrated shells
with no risk of crushing the cable.
Hanger hook and hardware are made of stainless steel AISI
304, and UV resistant shells are made with fiberglass PA.
|
Accessories
Sitemap